next up previous contents
Next: Finding a File in Up: The Virtual File System Previous: Registering the File Systems

Mounting a File System

    when the superuser attempts to mount a file system, the Linux kernel must first validate the arguments passed in the system call. Although mount  does some basic checking, it does not know which file systems this kernel has been built to suppor or that the proposed mount point actually exists. Consider the following mount  command:

$ mount -t iso9660 -o ro /dev/cdrom /mnt/cdrom
This mount  command will pass the kernel three pieces of information; the name of the file system, the physical block device which contains the file system and, thirdly, where in the existing file system topology the new file system is to be mounted.

The first thing that the Virtual File System must do is to find the file system.

To do this is searches through the list of known file systems by looking at each file_system_type  data structure in the list pointed at by file_systems .

If it finds a matching name it now knows that this file system type is supported by this kernel and it has the address of the file system specific routine for reading this file system's superblock. If it cannot find a matching file system name then all is not lost if the kernel is built to demand load kernel modules (see Chapter gif). In this case the kernel will request that the kernel demon loads the appropriate file system module before continuing as before.

Next if the physical device passed by mount  is not already mounted, it must find the VFS inode of the directory which is to be the new file system's mount point. This VFS inode may be in the inode cache or it might have to be read from the block device supporting the file system of the mount point. Once the inode has been found it is checked to see that it is a directory and that there is not already some other file system mounted there. The same directory cannot be used as a mount point for more than one file system.

At this point the VFS mount code must allocate a VFS superblock and pass it the mount information to the superblock read routine for this file system. All of the system's VFS superblocks are kept in the super_blocks  vector of super_block  data structures and one must be allocated for this mount. The superblock read routine must fill out the VFS superblock fields based on information that it reads from the physical device. For the EXT2 file system this mapping or translation of information is quite easy, it simply reads the EXT2 superblock and fills out the VFS superblock from there. For other file systems, such as the MS DOS file system, it is not quite such an easy task. Whatever the file system, filling out the VFS superblock means that the file system must read whatever describes it from the block device that supports it. If the block device cannot be read from or if it does not contain this type of file system then the mount  command will fail.

Figure: A Mounted File System

Each mounted file system is described by a vfsmount  data structure; see figure gif. These are queued on a list pointed at by vfsmntlist .

Another pointer, vfsmnttail  points at the last entry in the list and the mru_vfsmnt  pointer points at the most recently used file system. Each vfsmount  structure contains the device number of the block device holding the file system, the directory where this file system is mounted and a pointer to the VFS superblock allocated when this file system was mounted. In turn the VFS superblock points at the file_system_type  data structure for this sort of file system and to the root inode for this file system. This inode is kept resident in the VFS inode cache all of the time that this file system is loaded.

next up previous contents
Next: Finding a File in Up: The Virtual File System Previous: Registering the File Systems

David A. Rusling